2006
- 2015 Yamaha FZ1 Page
My recommended best resource for
this bike
This the original community, has the most information, and longest history
about this bike.
Join for free and become part of it.
WWW.FZ1OA.COM
Ivan's® ECU flash for:
2006 - 2015 Yamaha FZ1 - $350.00 + Return shipping.
**ALL NEW ECU FLASH FOR THIS MODEL**
** RE-TUNED WITH OUR NEWLY UPDATED SOFTWARE FOR THIS MODEL**
** UPDATED WITH NEW FEATURES LEARNED IN THE PAST 10 YEARS**
**NO ADDITIONAL FUEL TUNER USED**
Ivan's Performance ECU flash is for CLOSED COURSE COMPETITION USE ONLY !!
***** CLICK HERE FOR FZ1 ECU FLASH PREPARATION *****
***** CLICK HERE FOR FZ1 AIRBOX MODIFICATION PHOTOS *****
My ECU tuning philosophy and more ECU info can be found on this page: ECU PAGE
When sending your ECU, please print and fill out THIS FORM
I will contact you for your payment after I receive your ECU.
Testimonials can be found on THIS PAGE
____________________________________________
My FZ1 ECU programming (Re-Flash) includes the following:
1) Fix all fueling problems inside the ECU.
(The ones that cannot be fixed with an external fuel tuner or other commercially available methods)
• All gear dependent fuel maps fixed.
• Main fuel tables (A/n) - adjusted in all active throttle positions.
• Vacuum tables (MAP)- adjusted in all active areas.
• Emissions compliant sub-routines that affect driveability - turned off.
• All system response delays (detuning items) - turned off.
• Acceleration enrichment thoroughly tested and re-adjusted for correct response with new sub-throttle settings.
• Optimize injector timing for best power, response, mileage and combustion efficiency.
• O2 sensor disabled - No need to unplug, or can be removed if desired.
• Close AIS valve in flash - no need for block-off plates !!
• Disable EXUP code - no need for servo eliminator !!
External fuel tuner not needed - just plug in and go !!
2) Disable fuel cut - ie; Jerky throttle - (ours exclusively)
Don't know what "fuel cut" is? - CLICK HERE
Fuel Cut demonstration videos here:
Enabled: https://www.youtube.com/watch?v=Ue4SKOcHSUk
Live datalog https://www.youtube.com/watch?v=wgBznc8yXJc
Disabled: https: https://www.youtube.com/watch?v=0jrDHTcHwN4
Live datalog Disabled: https://www.youtube.com/watch?v=7i2vCGnyuGk
• Engine stays running when the throttle is closed.
With stock ECU programming, the injectors are not running when you decel.
(please see the demonstration videos above)
• Gets rid of poor, imprecise throttle transitions from closed throttle.
• Eliminates all feelings of driveline lash and jerky, delayed throttle response.
• Changing gears is dramatically improved. Without fuel cut disabled, there is no "neutral throttle"
This is the direct cause of your touchy, jerky throttle because the engine isn't running during decel.
• Dramatic improvement upon re-application from closed throttle in all riding conditions.
(Throttle re-application response feels like our old carbureted bikes used to feel)
• No need for a different throttle tube ratio to try to prevent jerky response.
(which it cannot do anyway)
• Gets rid of annoying popping and banging when re-applying the throttle from closed.
3) Close AIS valve electronically
• No need for block-off plates for air injection system
• No popping on decel !!
• No hoses to plug - Just plug in your ECU and go !!
4) Cooling Fan comes on at 195 degrees and goes off at 186
5) Reprogram sub throttles for best response and to remove power restrictions
• This allows a more sensitive throttle that is easy to control.
• Allows all of the FZ1 engine's available power - whenever you ask for it.
• Gives immediate engine response to the throttle with no restrictions.
• Low rpm power is dramatically improved, while preserving fuel economy.
• Response delay filters turned off - part of original detuning
6 ) Complete custom re-curve of ignition timing
• Set main timing tables for maximium power and driveability across the entire rpm range and all throttle positions.
This also helps provide better fuel economy, and less vibration when cruising and moderate acceleration.
• All gear dependent maps equalized and adjusted for best power and fuel economy.
• All emissions compliant / gear dependent detuning sub-routines turned off.
7) Raise rev-limiter to 12,300 rpm
• Raising the rev-limiter on this engine (700 rpm) up to 12,300 rpm allows the power to continue with my ecu programming.
8) Reduced heavy engine braking on decel.
•More relaxed gear changes and throttle modulation at all speeds.
•Chassis is more stable because bike doesn't pitch back and forth on it's
suspension when throttle is closed and re-applied.
• More stability when entering a turn.
• Slowing down is relaxed and natural feeling... Not like you just hit
the brakes.
9) Improved fuel economy
10) Reduced running temperatures
• Coolant temps average appx 25 degrees cooler than with stock programming
11) All power limiters removed
12) All driveability inhibitors removed
FZ1 engine revs instantly, and offers fantastic fuel economy too !!
13) Free updates when/if we make improvements.
(shipping not included)
14) Return your ecu back to stock at no charge for any reason.
(shipping not included)
15) Anything that compromises performance and/or driveability is eliminated.
External fuel tuner not needed - just plug in and go !!
All testing and tuning was done in house on my personal Yamaha FZ1 shown above !!
Dyno tuning not necessary !!
We reprogram for USA and Canada !!
ECU reprogramming may not comply with federal safety/emission laws !!
ECU reprogramming may not comply with your warranty !!
Ivan's Performance ECU flash is for CLOSED COURSE COMPETITION USE ONLY !!
New dyno charts coming soon !!
Old ECU flash w/power commander (now obsolete)
Stock ECU Vs. Ivan's ECU programming
All mods the same (full yosh, a/b mod, BMC filter PC5 w/mapping) No FCE, Same day test
